Installation Instructions for Scalewatcher (short version)

Do it yourself installation is quick and simple - and does not require a plumber or the cutting of pipes.
1- Locate the pipe where your water supply first enters your building.
2- Secure the signal cable with a cable tie (provided), wrap the cable twenty times around the pipe, secure with another cable tie, wrap twenty times going back on top of the existing coil, secure with a cable tie. (Smaller models require only 18 wraps)
3- Connect the signal cable to the Scalewatcher unit and plug into 110 Volt outlet.
Easy installation also means that, should you move, Scalewatcher™ is simple to disconnect and to take with you.

Detailed step by step instructions are included in your user manual . Here's what the finished coil will look like:

Double layer coil, back view	Coil, front view: one cable ends up on each side
The pictures below are for clarification only so you understand what NOT TO DO.
Wrong coil, it's twisted back	Wrong coil front: both cables end up on the same side
Close this box to go back to RESIDENTIAL